RRC 1258 Support in English > Configuration, RRC 1258
problem connect local network
(1/1)
DM1CG:
hY
i have a problem , that my RRC didnt connect to my local RRC (IC706)
remote all is running :-(
FW 2.95
via telnet and debug Control Unit:
ping: send 8.8.8.8
ping: recv 8.8.8.8 [4ms]
discoveryRx: Cmd Scan
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
New UDP CmdTxPort=11040
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
New UDP CmdTxPort=11040
R-> Radio ON requested (2)
rtp enable [192.168.99.169/11050 192.168.99.169/11050]
R-> Connection established, radio ON, audioQuality=2
duplex: New Audiocoding 102 (8 KHz)
R-> Radio '8V off' from panel
R-> Sending '8V is off'
rtp disable
audio = IDLE
mic-volume = -12
ping: send 8.8.8.8
ping: recv 8.8.8.8 [4ms]
"Remote UNit"
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
New UDP CmdTxPort=11040
rtp enable [192.168.99.131/11050 192.168.99.131/11050]
audio = DUPLEX
CP-> Sending 8V: 0 Mute spk: 0
CP-> audioQuality=2
duplex: New Audiocoding 102 (8 KHz)
CP-> Panel '8V off' from radio
CP-> Radio/Panel OFF (0)
rtp disable
duplex: New Audiocoding 102 (8 KHz)
Remote is sending Panel/8V is off and rtp disable ?!
Both sides same config.
Where is my error ?
73 de Carsten
DM1CG:
I was using one side DM5AL adapter and on the other side - homemade cable
Bothside home made running .
Bothside DM5AL doesnt work.
73 de Carsten
DM1CG
dj0qn:
Carsten,
am besten kannst du mit mir direkt in Verbindung setzten: dj0qn (at) darc (dot) de.
73,
Mitch DJ0QN / K7DX
Navigation
[0] Message Index
Go to full version