RRC 1258 Support på Svenska > Konfiguration av RRC 1258

RRC1258, K3/0 mini no SSB output

(1/2) > >>

cx6vm:
Hello

My setup with K3/0Mini and remoterig boxes was working fine

Now after some months not doing a phone qso, I tried again but no audio out. I am usinh MH2 microphone with the K3/0 mini. I can see my amplifier client showing 1200 watts, but no ALC bars on K3 display, I was monitoring me but not listening my voice.

I had some storaged messages on K3´s M1, M2, M3 and M4 memories and the work OK, perfect output audio showing ALC bars on my K3 display

Any idea what may I check?

thanks!

Jorge
CX6VM

sm2o:
Check that you have selected the correct mic in the K3 menus, back or front etc?

/mike

cx6vm:
hello Mike

I tried with all options

MIC SEL = rP.H
MIC SEL = LInE In
MIC SEL = FP.H bIAS

etc

73,
Jorge

sm2o:
if you should us rP = rear panel or FP = front panel depend s on where you have conencted the Mic cable.
Also check the codec gain settings in both RRCs

73

cx6vm:
Hello

I imported a good setting files on each RRC1258 boxes.

Maybe the audio cable on the remote side is disconnected?

Don´t know what more to check in my side

73,
Jorge
CX6VM

Navigation

[0] Message Index

[#] Next page