Messages

1

General discussion forum / Re: Icom 7100 problem

« on: 2026-01-09, 02:00:49 »

Thank you.  I will give that a try.
73
Terry N7BDL

2

General discussion forum / Icom 7100 problem

« on: 2025-11-19, 16:45:49 »

I have three remoterig setups:
Elecraft K3 ID to AZ
Icom 7100 ID to AZ
Icom 7100 AZ to ID
These have been in service for years.
The K3 works well, but both 7100s now have no transmit audio.  They connect and receive as normal.
I have screen shots from when they were working, so I can see that nothing has changed in the setup.
The head and microphone work correctly when connected directly to the radio.
I have removed and cleaned the jumper boards (applied deoxit).
Any suggestions?
Thanks
Terry N7BDL

3

General discussion forum / Re: Problem with Alinco DX-SR8E

« on: 2017-01-30, 20:34:41 »

Thank you for the information, Mike.  I will not waste any more time on it.  I was setting it up for a friend who is now in assisted living.  He is using my 706 right now, but the 480 would be much easier for him to read. He has a Kenwood TM-G707 for V/UHF, so he only needs HF.
73
Terry N7BDL

4

General discussion forum / Re: Problem with Alinco DX-SR8E

« on: 2017-01-30, 16:26:55 »

I see that no answers were posted for this question.  I have the same problem.  Any suggestions?
73
Terry N7BDL

5

General discussion forum / TM-G707

« on: 2012-05-11, 18:17:12 »

Has anyone used a Kenwood TM-G707 with remoterig?

73
Terry
N7BDL