Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - N7QT

Pages: [1]
1
Configuration, RRC 1258 / Re: RRC 1258MkIIs Update problem
« on: 2014-02-25, 16:01:39 »
Jan,
Thank you very much for the update. I was able to change the devices IP address, then update the firmware in both devices. The devices are now communicating over my internal home network. 

Next I will try to transmit using my Kenwood TS480 on CW/SSB to test the strapping.

-rob

2
Configuration, RRC 1258 / Re: RRC 1258MkIIs Update problem
« on: 2014-02-24, 21:04:07 »
Invalid data in setup data even after the both 1258 devices reset to factory defaults??? Not good.

I can't use the web interface because my home network isn't on a 192.186.0.x IP range. Therefore I can't reach the default 1258 web servers. I'm also unable to change the 1258 IP address using the Setup Manager application via USB because of this software bug/exception. There really should be a jumper setting to allow the device to use DHCP, which would allow me to get to the web server.

Looks like I will have to setup a router/network for 192.168.0.x just to get access to the 1258 web server.  So far this has been a pretty painful experience.  :-(

-rob

3
Configuration, RRC 1258 / Re: RRC 1258MkIIs Update problem
« on: 2014-02-24, 00:19:22 »
To use the web interface don't I need to use Microbit Setup Manager to update the device IP address and subnet mask in order to join my network?

I go to the Setup tab in Setup Manager, click on the button "Get from device" and get to see the devices information in the dialog box(default values).  Even if I make, or don't make a change to the contents of the dialog box, as soon as I press the "Save to device" button, I get the following error:

Unexpected Exception
Exception: Index was out of range. Must be a non-negative and less than the size of the collection.
Parameter name:index
Module: Form1:Void
SetupGetterBackgroundWorker_DoWork(System.Object,System.ComponentModel.DoWorkEventArgs)
Method:ThrowArgumentOutOfRangeException

4
Configuration, RRC 1258 / RRC 1258MkIIs Update problem
« on: 2014-02-22, 21:11:17 »
I'm trying to update my device and am getting an error.

Using Microbit Setup Manager v1.25 states FW/HW version:
Version=006, Firmware=2.25, Bootloader=N/A, HW=006

When trying update my device to v2.78 the update fails with the following sequence:
Failed programming new firmware: Write failed: -1
Transferring firmware..
FW/HW version successfully retrieved
SW Version Successfully retrieved

Suggestions?

-rob

Pages: [1]