1
General discussion forum / Re: Webswitch 1216H
« on: 2012-08-16, 02:18:56 »
Switched to a Green Heron RT-21 controller and everything is working.
Ernie W6ETS
Ernie W6ETS
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General discussion forum / Re: Webswitch 1216H
« on: 2012-07-29, 15:33:22 »
Mike
According to HyGain their DCU-1 controller can not send the current position of the rotator to the computer. We therefore can control the rotator and turn it but can not see what its position is on the compass rose. We will rely on the presets to point the antenna to a given bearing.
73
Ernie W6ETS
According to HyGain their DCU-1 controller can not send the current position of the rotator to the computer. We therefore can control the rotator and turn it but can not see what its position is on the compass rose. We will rely on the presets to point the antenna to a given bearing.
73
Ernie W6ETS
3
General discussion forum / Re: Webswitch 1216H
« on: 2012-07-16, 23:09:49 »
Tnx for all your help. I don't understand what you mean by check to see if we have the right protocol. Can you please explain this.
Tnx and 73
Ernie W6ETS
Tnx and 73
Ernie W6ETS
4
General discussion forum / Re: Webswitch 1216H
« on: 2012-07-16, 21:20:16 »
We are using your RS 232 adapter cable 1216S connected from the webswitch to the RS 232 connector on a HyGain DCU1
antenna contol.
We are using the computer to browse to the Webswitch. We see the compass rose with disabled on it. The presets will rotate the antenna and a bearing entered in the lower left box also will rotate it.
antenna contol.
We are using the computer to browse to the Webswitch. We see the compass rose with disabled on it. The presets will rotate the antenna and a bearing entered in the lower left box also will rotate it.
5
General discussion forum / Re: Webswitch 1216H
« on: 2012-07-15, 23:30:06 »
Correction we enter degree setting in lower LEFT box not right.
Ernie W6ETS
Ernie W6ETS
6
General discussion forum / Re: Webswitch 1216H
« on: 2012-07-15, 23:22:58 »
Activated Webswitch and it is turning the rotator. We can enter the setting in the lower right box or press the presets and the rotator will turn to that position. The compass rose has disabled across it and we do not get an indication where the antenna is pointing. Any suggestions? Operating system on computer Windows 7.
Ernie W6ETS
Ernie W6ETS
7
General discussion forum / Webswitch 1216H
« on: 2012-07-13, 21:38:16 »
Our club recently installed a Kenwood TS480SAT with a Remoterig for remote operation and all is working well.We now are trying to install A Webswich 1216H for rotator control. The rotator is a HyGain Tailtwister T2XD with a DCU digital control unit.I was told to buy the RS-232 Adapter cable 1216S when I bought the Webswitch. I can't figure out how to connect the end of the cable that has what looks like a header connector to the Webswitch. I would appreciate some help.
73 Ernie W6ETS
73 Ernie W6ETS
Pages: [1]