Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - N3AD

Pages: [1]
I have connected USB cable from RRC control unit to computer USB port. Microbit shows Unknown disconnected!. I have tried several USB ports and a different cable. I then tried a different computer and still no connection. Is it possible I inadvertently changed a setting which is causing this? In every other way the system is working.


Configuration of Routers, Firewalls, etc / DDNS setup issues
« on: 2013-10-02, 22:49:42 »
I have resolved a number of setup issues I had yesterday. Here is what still needs resolving.
I registered with which automatically put in the dynamic ddns info, so I think I'm good there.

Issues remaining
1. On the remote radio page, auto connect is set at no. When I change it to yes, it reverts back to no. Should it be no with the ddns activated?
2. Do I need to set ddns in my router to My router does not that have that option, only show disable, and I dont see any way of entering it manually. If this setting is needed, do I need to update firmware. I've been trying to do that and the upgrade will not accept the files I've downloaded from Lynsys but the installer won't accept it.
3. I am showing ipV4 connectivity but no ipV6 connectivity. Do I need ipV6?

Thanks and 73

Configuration, RRC 1258 / Set sip password now locked out
« on: 2013-10-01, 19:39:31 »
I am working through setting my ip settings. But at some point, I think after I registered with Microbit DynDNS. (Not sure if I'm actually registered) I set a password which I do have, but the login is also asking for a username which i have no idea of. I didnt set one. is it related to the serial number?

I also have some issues with ip setup, but need to resolve this first.

Thanks and 73

Pages: [1]