Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - WA2TTP Steve

Pages: [1]
Hello to the group.

When I operate remote I use my laptop with a network bridge set through windows to provide a link from the wifi to a lan connection for the 1558mkII. Using my toshiba laptops running windows 7 and Vista this works with any issues. I tried the same thing with the Ausu notebook running windows 8.1 and the network bridge. Using this computer the TS-480 will turn on and is functional in all respects except no receive audio comes through, transmit audio is fine. I figured maybe it was firewall issue so I went into the advanced firewall area and created new rules for Port 11000 udp and tcp both inbound and outbound. Still no good. I didn't have to do anything special to have it work with my other two laptops.

Any ideas?


I created an account with Dyndns and when I enter the info in the router, wrt54g, it comes back with a invalid domain name message. I cut and pasted it right out of Dyndns account page. Syntax:
I tried http:// in front of it and also / after it. Nothing makes it happy.
Not sure what is wrong.

I'm in the  process of setting up my 1258 and will also be adding a Digi TS2 serial server.

If I enter my DynDns host name in the router will that serve both the 1258 and Digi TS2 or do they need different names?


Configuration, RRC 1258 / Failed firmware update on 1258
« on: 2011-05-24, 06:32:19 »
I just received the units today and attempted to update the firmware per the manual.

I down loaded and installed Microbit Setup manager V1.9 to my Toshiba laptop running Windows Vista 32 bit.

The manager will connect to the units, via USB, and read there current versions, V2.33.

I down loaded the latest version V2.39, extracted the files to my desk top.

Selected the file on the manager and hit update. (C:\Users\Stevie\Desktop\RRC-1258-CRC_v2.39_2011-05-23.bin) After a few seconds I get the following:
Failed programming new firmware error code 31

I don't think I did anything wrong.


I'm looking to use a web hosting switch to control antenna selection and other functions in the shack and house. The switch is made by DLI, see link below. The RCC manual mentions web hosting devices should be moved off port 80 to port 8000 as an example.

My question is has anybody used this switch or any web hosting devices and had any problems?


General discussion / RCC control output
« on: 2011-04-25, 02:32:06 »
When using the PC client/RCC setup is there any way to get a control output from the RCC via the PC client? It would be useful to control power to the remote radio.


I'm new to the forum and looking to purchase a RRC 1258 MKIIs RCC Micro package but have question.
The package comes with the MKIIs version but will the client software and hardware work with the mono channel version?


Pages: [1]