Show Posts
1
Hardware, Cabling, Installations / 1216h+1216L set-up to Control a Yaesu G-1000DXC rotor
« on: 2021-03-10, 15:11:41 »
Hi all,
I'm new to using Remote Rig and still have some questions, but I would like to share already my solution for remotely controlling my Yaesu G-1000DXC rotor.
In my application I cannot use the factory provided controller, so I made my own
.
The only downside is that I no longer have the 450° capability since the Rotor Control software only allows an input to 359°.
But other than that, this works great.
Comments, suggestions or questions are welcome of course
.
I'm new to using Remote Rig and still have some questions, but I would like to share already my solution for remotely controlling my Yaesu G-1000DXC rotor.
In my application I cannot use the factory provided controller, so I made my own
.The only downside is that I no longer have the 450° capability since the Rotor Control software only allows an input to 359°.
But other than that, this works great.
Comments, suggestions or questions are welcome of course
.