Author Topic: JMP2 in control box for IC-7100  (Read 3379 times)

W4RG

  • Newbie
  • *
  • Posts: 5
    • View Profile
JMP2 in control box for IC-7100
« on: 2014-09-03, 23:16:42 »
Page 23 of the manual says that JMP2 should be in place to provide 8 volts to the display for all Icom radios.  The schematic for the 7100 indicates 8 volts are being used.  But page 101 says JMP2 should be removed.  Any comments or recommendations?  73, Ray

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3007
    • View Profile
    • sm2oan
    • Email
Re: JMP2 in control box for IC-7100
« Reply #1 on: 2014-09-04, 10:37:25 »
It should be 8V but it's not that important as there are Regulatotors which take it down 3V3 etc.
I will change page 101

73 de mike