Author Topic: contemplating purchasing remoterig for ic706mk2 - ease of setup ??  (Read 5262 times)

W1WWA

  • Newbie
  • *
  • Posts: 2
    • View Profile
    • Email
Hi,

I am contemplating purchasing Remote Rig to operate my ICOM IC706mk2 at my other QTH.  I am just looking for a basic no frill setup to run SSB,  my antenna will be a mutiband dipole so no need for a rotor or antenna switch.

I am planning on modifying the ICOM separation cable and I understand the instruction so that is not a problem.  Also I am planning on  using the Wifi adapters in both remote and radio units,  BUT is it easier to use the LAN port ??   I want this setup  as simple as possible

So my concern is once I getting the units working on the remote network at my current location then I move the radio side unit to my other QTH, what changes do I have to make to the remote and radio side units??  is there a "cheat sheet"  or any easy instruction ?,  I have never done this before and it seems a bit intimidating.  If there is some kind of step 1 step 2 etc cheat sheet someone has it would be appreciated.  My current location does not allow antennas so hopefully this works out

Need a fool proof setup,  QTH's are far apart so impossible to run back and forth.

thanks, Kurt W1WWA

PD1IM

  • Newbie
  • *
  • Posts: 17
    • MSN Messenger - ingmar77@hotmail.com
    • View Profile
    • Email
you can program 10 WIFI networks so switching location is no problem.  i use my 706 in the car, work on ship and at home without
any problems.