Author Topic: Webswitch Advanced Settings - Elecraft K3?  (Read 2705 times)

VO1HP

  • Full Member
  • ***
  • Posts: 117
    • View Profile
    • VO1HP
    • Email
Webswitch Advanced Settings - Elecraft K3?
« on: 2023-10-29, 13:58:47 »
I want to setup Antenna Selection function using WebSwitch 1216H.  Which Function Type do I use for my K3?

VO1HP
Frank
VO1HP
K3Mini-K3-RemoteRig

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3037
    • View Profile
    • sm2oan
    • Email
Re: Webswitch Advanced Settings - Elecraft K3?
« Reply #1 on: 2023-10-29, 19:55:48 »
Hi

use Kenwood(IF)

you can use the manual för as-1289, the control part is the same, just different hardware

http://www.remoterig.com/downloads/AS1289-Users_manual.pdf

73 de mike

VO1HP

  • Full Member
  • ***
  • Posts: 117
    • View Profile
    • VO1HP
    • Email
Re: Webswitch Advanced Settings - Elecraft K3?
« Reply #2 on: 2023-10-29, 21:58:54 »
Ok Mike
Many tnx for the fast reply.  I will use the AS1289 manual and Kenwood IF  setting.   

73 VO1HP
Frank
VO1HP
K3Mini-K3-RemoteRig

VO1HP

  • Full Member
  • ***
  • Posts: 117
    • View Profile
    • VO1HP
    • Email
Re: Webswitch Advanced Settings - Elecraft K3?
« Reply #3 on: 2023-11-06, 18:07:25 »
Mike
In manual page 28 Advanced Settings it says K3 uses Yaesu settings F2000/5000/9000.  Your note says use Kenwood IF?  Please clarify.

Also I cannot find in the manual how to set the WebSwitch 1216H to interface with the RRC Remote box 1258 .  Is it required to interface to read the frequency of the radio?.  The WebSwitch does not have RADIO-RRC Settings page. 

I have port forwarded UDP port 13010 to the IP address of the WebSwitch and also have Automatic Control ON.  Also have set frequency range for two relays  80MSSB and 60M .  When I tune to those frequencies I cannot see any thing happen with the relays.

Also in 1258  Remote Box STATUS page ANTENNA-SWITCH IP = Not Connected.

I need a bit more info on how to setup.  Thank you.

73 Frank VO1HP
Frank
VO1HP
K3Mini-K3-RemoteRig