Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - W6CZ

Pages: [1]
1
General discussion forum / IC-901???
« on: 2022-12-24, 00:07:50 »
I just finished setting up an Icom 2820 and I’m wondering if anyone has attempted the same configuration with an IC-901? I have one with the full complement of band modules that would be cool to set up as a remote.

73
Don
W6CZ

2
General discussion forum / Head & Mic cable length?
« on: 2011-01-21, 18:20:04 »
Anyone experemented with running long CAT5 cables between the Head/Mic and the control box? I am building a new house and I am considering putting a control box with a patch panel in the structured wiring panel and wall plates in a 2 or 3 locations around the house (where I have already run pairs of CAT5 - in some cases 2 pair) - office, hobby room, etc. Then I would just move the control head and the mic around to different locations as wanted.

3
v2.30

Updated rig unit no problem (dual RX units). Cannot update control unit. Progress bar goes to between 2 and maybe 6 segments and then times out with an error message unable to update firmware. Tried second unit - same result. Tried earlier versions of firmware - no luck. Tried one version earlier setup manager, still no luck. I am at a loss...

XP home SP3 Intel P4 2.8gHz - a bit short on RAM @ 512k

I'll try another machine tomorrow

4
General discussion forum / Transparent Mode?
« on: 2010-11-24, 20:32:10 »
There doesn't seem to be any documentation. Is there a PTT signal from a mic plugged into the remote box at the radio box? Any additional singaling available in either direction?

Pages: [1]