Messages

91

General discussion forum / Re: Failed updating using USB

« on: 2011-02-09, 15:56:46 »

Hi Jan

it was good talikg with you. As informed, i was using anothr win7-64 bit laptop and got same issue. Then my IT coworker was able to get the firmware via the web and install it.

Thanks for your help. i will keep moving with the configuration.

BR
Ziv-4z4oq

92

General discussion forum / Re: Failed updating using USB

« on: 2011-02-09, 12:22:58 »

Hi

Nowthe bar is moving forward for 8 sec about 3cm from the end... AND i am getting the error code 31

93

General discussion forum / Re: Failed updating using USB

« on: 2011-02-08, 17:30:50 »

the bar stop about 2cm after its starting

94

General discussion forum / Re: Failed updating using USB

« on: 2011-02-08, 17:29:13 »

you are correct - the v1.8 is the setup manager vertion.

here is a picture of the ver i can read

95

General discussion forum / Re: Failed updating using USB

« on: 2011-02-08, 16:58:37 »

thanks for quick answer!! -  From v1.8 - the bar in moving 5 sec...

96

General discussion forum / Failed updating using USB

« on: 2011-02-08, 16:16:27 »

Hi

I am totally new with remote and got the RRC last month visiting USA. I am also not big expert on computers but have some help from my IT co-work. I connected the equimpnet to the web and the USB cable to my laptop computer. Win7-32bit
When starting to install the new F/W i can see the green bar moving and then get a "failed programming new firmware: write failed" messge.

Please help