Author Topic: RRC1258 status page: output status issue  (Read 1314 times)

pe1hzg

  • Newbie
  • *
  • Posts: 11
    • View Profile
RRC1258 status page: output status issue
« on: 2024-04-17, 20:25:27 »
(for reference: RRC1258 version 7, software 2.95)

I think I found an issue with the RRC1258 status page which I have not seen reported on the forum, so I'm calling it in:
I think the status for Output 1 and Output 2 are reversed on the Status page.

How to repeat: configure Output 0 and Output 1 as Connect, Output 2 as On/Off.
Do not connect to a control-RRC and leave Output 2 as Off
Go to Status page and notice that all outputs report as status Low.

On I/O settings page, flip Output2 to On. Notice that the OUT2 On/Off indicator is now green ("ON").
Go to Status page and notice that Output1, not Output 2, reports as high.
That is wrong: Output2 should be reported High, not Output1.

On I/O settings page, flip Output2 back to off. Notice that all outputs now report Low.

Connect a control RRC. When the connection is up, OUT0 and OUT1 will activate.
However, when checking the Status page, now Output2 reports as high and that should be Output1.

This isn't the end of the world but I found it when building scripts. Separate message about that.
I'm surprised this wasn't reported before though.

73, Geert Jan PE1HZG