I have had a working station using a K3/0 and K3 with RRC boxes for 6 months. While troubleshooting a minor issue, I made a change to the baud rate in the K3 configuration. It locked up the K3/0 and perhaps the K3 (Im not on site so can’t observe).
When turning on the K3/0 a connection is indicated by the beep and TERM … but no additional data is transmitted. No knobs or switches are functional
I suspect I corrupted something in my K3 configuration file. Does this make sense? I suspect that the config file will need to be reloaded. I believe this can only be accomplished on site?
Comments welcome
Dennis, K7FL
Home: Las Vegas, NV
Remote: Belgrade, MT
