Hello
I couldnt setup remoterig with two K3/100 radios, so right now, I bring both radios to my house and start over with the setup
I turn on control radio, then turn on remote radio, but nothing happen. I hear on the headpones a continue sound like telephone sound, "u i u u i u u i u u i u u i u....................."
I am following this two manuals:
Elecraft Manual
http://www.elecraft.com/manual/K3%20Remote%20Owner%27s%20Manual%20%20Rev%20D.pdf and
Remoterig Manual
http://www.remoterig.com/downloads/RemoteRig_RRC1258-MkII_Users_manual.pdfI couldnt open remoterig boxes to check inside as per Remoterig manual page 213
I update firmware on two remoterig boxes
I go to the browser and access microbit to go to radio settings. Here some diferences with manuals and browser
- SIP password, Elecraft manual say blank, Remoterig manual say hello
- SIP contact may I left blank or not?
- Audio quality, Elecraft manual say "3 - aLaw 12 kHz" and remoterig manual say "2 - Linear 16 bits 8 kHz, so which one is the correct?
- Codec Out Gain Elecraft manual say 250 and Remoterig manual say 255
- Codec Imp Gain Elecraft Manual say 32 and remoterig manual say 14
- Codec inp preamp Elecraft manual say "163", Remoterig manual say "Yes"
router setup also is diferent in Elecraft and Remoterig manuals on applications name, but maybe this is not a problem
Any idea what is wrong?
--
73,
Jorge
CX6VM/CW5W