Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - DL7AV

Pages: [1] 2
I have seen an application for that but cannot find it again. 1216H.
73,  Thomas

thank you Mitch. I have tried this, maybe the port number I tried was occupied.
73,  Thomas DL7AV

Hi,  two webswitches possible on same remote location to be able to use 10 relays?

General discussion forum / Re: no temperature readout
« on: 2013-10-30, 22:08:43 »
thank you Jan. Deleting and rescanning was the solution. I just did not imagine that I had to delete something!!
regards,  Thomas

General discussion forum / Re: no temperature readout
« on: 2013-10-28, 17:58:12 »
Hi Jan,

sorry I did not find a Manual for the Webswitch, so I don't know what you mean by scanning the sensor!? It is the only sensor and the polarity is OK.

regards,  Thomas

General discussion forum / no temperature readout
« on: 2013-10-28, 11:38:46 »
this is probably easy to answer. I get no correct temperature readout:
Current Temp A(IN): Current 0.0625, Max 0.0625 , Min 0.0625
sw 3.3
Build Jun 12 3013
What to do?
Thomas  DL7AV

General discussion forum / Re: JT65 via Remoterig?
« on: 2013-08-15, 15:46:37 »
Hi John,

thank you! That's very important news for me, saves me time.

73,  Thomas  DL7AV

General discussion forum / JT65 via Remoterig?
« on: 2013-08-10, 08:44:42 »
Hi all,
before I try it: Has anyone used Remoterig for the reception of weak signals via JT65? What settings did you use to receive signals below the noise level? "0-alaw 8 kHz" will probably not work, maybe "linear 16bits 8 kHz"?
73,  Thomas  DL7AV

do I understand correctly that your solution cannot be used if you already use the IO ports for CW keyer plus paddle?

73,  Thomas  DL7AV


Hi Staffan,
my compliments for your web controlled Antenna Connection system. Lightning energy is prevented to get into the shack through the coaxial shield. I have not seen that before. You seem to use special N-connectors with no lock nut.

73,  Thomas  DL7AV

Configuration, RRC 1258 / Re: how to delete profiles?
« on: 2012-02-04, 18:26:30 »
Thank you Jan, good service!
But "Remember to "Submit"" has to be moved to 3/
Works fine now.
73,  Thomas

Configuration, RRC 1258 / Re: how to delete profiles?
« on: 2012-02-04, 12:34:04 »
"So "blocked" means the profile you change to has the wrong IP settings for the network the RRC is in?" YES
This is the exact info:

profile: “default”, good connection
IP address

profile: “dl7av”, must be changed or deleted, wrong network settings. By Setup Manager:
IP address:
Netmask   :
Gateway   :
DNS       :

Configuration, RRC 1258 / Re: how to delete profiles?
« on: 2012-02-03, 18:37:59 »
Thank you Jan. But there may be a misunderstanding. As you said I changed from default profile to the profile that does not give me access, but did not submit. Then I changed my password in the IP settings and applied. Same result, the profile does not work because it is looking for a wrong network (as I can see in the “Net info” in the setup manager). Any way to change the settings of the profiles which look for a different network? Factory reset??
73,  Thomas DL7AV

Configuration, RRC 1258 / how to delete profiles?
« on: 2012-02-03, 12:56:43 »
I now have 3 useless profiles due to playing around with the settings at different locations. When choosing one of those the access is blocked and I have to use the setup manager via USB to get to the default profile. How to delete profiles? And how to rename them?
73,  Thomas  DL7AV

Thank you. Jan, is the beep (after pressing the start button at the TS-480) an indication that the setup is basically ok? No way to get a display or audio by different ways of pressing the button. - I wanted to bridge the two connections at first. But Windows XP says I can only bridge two LAN or high speed internet connections, the USB 3G modem is different. For the time being I have given up. Thanks and good luck for further developments with the wonderful Remoterig. 73
Thomas DL7AV

Pages: [1] 2