1
Hardware, Cabling, Installations / Getting CI-V on the radio side
« on: 2017-10-22, 00:16:53 »
Hi!
When working locally I use MK2R+ and it's CI-V (ACC connector) output to control OM-Power automatic amplifier.
When remote I would also like to get CI-V output on RRC-1258 MkII: Radio unit in order to control OM-Power amp, the station used is TS480. Is this possible?
I can get Kenwood RS232 data on COM1 on Radio unit and route the cable to OM-Power amplifier but it has a serial port disabled when CI-V connector is present.
Any ideas please?
73
Simon, S53ZO
When working locally I use MK2R+ and it's CI-V (ACC connector) output to control OM-Power automatic amplifier.
When remote I would also like to get CI-V output on RRC-1258 MkII: Radio unit in order to control OM-Power amp, the station used is TS480. Is this possible?
I can get Kenwood RS232 data on COM1 on Radio unit and route the cable to OM-Power amplifier but it has a serial port disabled when CI-V connector is present.
Any ideas please?
73
Simon, S53ZO