Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - partytyme

Pages: [1]
General / reset trail please
« on: 2018-12-18, 13:37:48 »
i have a galaxy 9 now i could not get the app to work on a galaxy 7 can you please reset my trial so i can see if it will work on my galaxy9+ please  73 n8obu

General discussion forum / choppy tx audio
« on: 2018-03-05, 00:40:41 »
i have  an remote rig setup with two control heads  using a kenwood ts2000 they both work great when in the house  one is wired and one has a wifi card in it for portable use  i ordered a franklin wifi hot spot on sprint network after testing it using my galaxy s7's hot spot on sprint  it worked great on the phone but now that i switched over to the franklin hot spot  i am told it sounds like i have a cards stuck in a bike spokes choppy on tx only  i did a speed test on the franklin hot spot and it came back 29 ms ping 6 mg up 3 mg down my phone would not even  do 2mg down  and .5 up
i ordered the hot spot because i could get it cheaper than leaving the hot spot on my phone on they wanted 50.00 for 5 gig on my phone ..i found a way to get the franklin hot spot for 20.00 a month unlimited this is why i switched,,  any tricks i should try?

 have my  kenwood st2000 working great and i can run it mobile using my sprint phone's hot spot  when driving  now i want to be lazy and build a 2nd control  for home use  i have a rc-2000  head and a tm-d700 head and they both work i swapped them to test them so any tricks to having them both connect up? i know i can only use one at a time . i figure i will have to turn the power off to the unit not in use  thanks for your input before i order the 2nd control box     mike n8obu

 today i swapped from a ts2000 to a ts480  all went well but.. if i turn off the ts480  it turns off then turns it self back on lol if you set the auto power off in the radio it turns off as requested i am sure i missed something simple.   

ok i have a working system using a ts2000 no issues  i picked up a ts480 sat and would like to be able to swap them out i have made the 6 pin cat cable for the mic and two short jumpers to go from the rigs to the control head and main unit and tested them by hooking the head up and both cables work fine , i have went in and changed the rig types from ts 2000 to ts 480 on  both 1258's and updated it but the rig will not turn on remotely  what an i missing? thanks for looking

General / nano and galaxy s7 not working
« on: 2017-11-05, 04:01:31 »
ok i down loaded the app hooked up the cat cable the first time i turned it on i got audio no display now no audio or display   says connected , uninstalled it but it back on  same thing happens  works fine with my rc200 head what is the noobie missing?

General discussion forum / maybe a simple question
« on: 2017-10-31, 23:07:05 »
can you setup the 1258 radio to work with the  rrc nano app for android if so  what rules do you have to live by i would like to use the android app and the receiver but not at the same time

General discussion forum / ts 2000 no smeter on ssb
« on: 2017-10-31, 00:14:14 »
my remote rig works ok but i have no s meter readings on signals coming in if i change modes they show up ok i am using a rc2000 head 

Pages: [1]