Show Posts
1
Hardware, Cabling, Installations / Microham MKII and Remoterig
« on: 2017-07-26, 09:10:35 »
Hello. I have a yaest ftdx5000 and remoterig and I am thinking to buy a Microham MKII. I would like to have them all connected so I can operate the 5000 either remotely either locally without to need to change cables.
What I thought is
1. connect 5000 cat port to remoterig com2 (mode 4). JMP3 connected and a cable 1 by 1 (I think only 2-2, 3-3, 5-5, 7-7,8-8 is needed, right? or only 2,3,5 and just the JMP3 is enough for 7 and 8?)
2. connect remoterig com1 to computer's com1. Mode 6 in remoterig's com1. Right? I am little bit confused with the cable. Is right that I need to connect 2-3, 3-2, 5-5, 7-8, 8-7?
Anything more tip that I didn't give attention?
What I thought is
1. connect 5000 cat port to remoterig com2 (mode 4). JMP3 connected and a cable 1 by 1 (I think only 2-2, 3-3, 5-5, 7-7,8-8 is needed, right? or only 2,3,5 and just the JMP3 is enough for 7 and 8?)
2. connect remoterig com1 to computer's com1. Mode 6 in remoterig's com1. Right? I am little bit confused with the cable. Is right that I need to connect 2-3, 3-2, 5-5, 7-8, 8-7?
Anything more tip that I didn't give attention?