Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 2W0NRE

Pages: [1]
1
Hardware, Cabling, Installations / A mount now exists
« on: 2021-02-01, 12:50:20 »
Designed & printed over the weekend.

https://www.thingiverse.com/thing:4745994

Niamh

2
Hardware, Cabling, Installations / Mount
« on: 2021-01-30, 10:07:20 »
Has anyone 3d printed a mount for a RRC 1258? I looked on thingiverse and didn'y find one.

Niamh

3
In memory channel mode pressing the up or down buttons on the microphone doesn't change the channel but turning the select knob on the control works as expected. I think the mic is working properly as when plugged directly into the radio the buttons work as expected.

I'm using the FT-857 strapping headers supplied with the RRC-1258s but suspect that mic pins 1 & 2 need connecting



Niamh

4
Just doing the initial setup and thought I'd check that the remoterigs were connecting but I'm seeing Disconnected, is this expected with no radio gear attached, or have I done something wrong?

Niamh

Pages: [1]