Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - GW0WZL

Pages: [1]
I was looking at the antenna switch web page the radio was in rx and it turned off the antenna selection that was on. I could then not access the web page. Using the setup manager the server port had changed from 80 to 65556 and then I could not log in the user name was ok and the stars in the password were the correct amount. I did a reset and everything worked except it now thinks it is a RC-1216H and I can not get the automatic antenna selection because the functions are rotators and not radios.
Please help

Company   Microbit
Product   RC-1216H
Software   4.59
Hardware   2
Bootloader   1.10
Build   Dec 10 2019 13:16:00
S/N   2523
PID   4294966700
Uptime   0 Days, 0 Hours, 21 Mins, 54 Secs
MAC   00:1e:fd:00:c7:b3
IP address
Max available memory   18401
DNS status   OK, =
Dynamic DNS status   Inactive
Ping status (watchdog)   Off
Active profile   Default
Last WD Reset   12
TCP Error counter   0
Webserver   1

I have a strange problem that I cannot solve. I have an Icom 7100 connected across the local LAN with 2 1258 boxes and a 1289 antenna switch. The antenna switch works perfectly, and is connected with a genuine ICOM ci17 ci-v. The problem is that at irregular intervals whilst the radio is in receive then the mode will change from usb to lsb or to AM or usb-d. This is totally random the radio is not in tx there is no other software ie wsjtx controlling the radio the antenna is not being switched, no other radio is being operated. With the cable from the radio to the Icom ci-v interface disconnected then the mode never changes, but then the antenna switch will not work automatically.

General discussion forum / Icom CI-V
« on: 2022-06-24, 16:11:47 »
Does any one know if it is possible to split the Icom CI-V from out of the radio. I have remoterig 1258 connected to my 706mk11g and it all works great, however I also use digital modes on a pc at the remote site and need to connect the CI-V to the PC so that I can control the software via CI-V. Is it possible to split the cable from the 706 to the PC and remote rig?

Hi is it possible to split the ci-v signal from the Icom 706? I am using the rrc antenna switch which automatically switches the antennas when the ci-v is connected to the rrc 1258 radio, but I need the ci-v connected to the computer for my log book. FT8 etc
How do I share the ci-v data please?

Pages: [1]