Messages

31

General discussion forum / INFO on CW switching

« on: 2010-01-20, 19:14:40 »

Hi ALL
Can anyone help and inform me if: are ALL three UT0,1,2 I/O OUTPUTS on radio RRC unit keying (ON-OFF) simultanously during CW keyer operation, or ONLY the I/O output UT0 is keying (ON-OFF) as the CW output of the keyer??
Tnx & 73
Costas

32

General discussion forum / Re: Using RRC as remote switch

« on: 2010-01-18, 21:25:59 »

Tnx again Mike.
Pse a final clarification from you on this item: are ALL three UT0,1,2 I/O OUTPUTS keying (ON-OFF) simultanously during CW keyer operation, or ONLY the I/O output UT0 is keying as the (ON-OFF) output from the keyer??
Tnx & 73
Costas
 

Hi
No if you have not acivated the keyer. They are acting separate from each other.
73 de mike

33

General discussion forum / Re: Using RRC as remote switch

« on: 2010-01-18, 13:30:04 »

Tnx info Mike.
May I ask you further if I can use I/O  UT2 OC output separetely for PC reset when CW keyer is deactivated, or ALL I/O outputs are switched ON-OFF simultanously during CW operation producing continous PC resets?
  

34

General discussion forum / Using RRC as remote switch

« on: 2010-01-17, 18:51:52 »

I would like to know if I can use RRC1258mkII as a remote switch, for example to reset my nearby PC using a small external relay at the I/O connector, and at the same time to have RRC connected also throught I/O for CW (straight) key operation on TS480.
Is any conflict on RRC firmware for such configuration?
How can I give such a command for reseting the PC?
73 Costas

35

General discussion forum / TS480 dual control and CW latency

« on: 2010-01-05, 12:47:11 »

I have TS480 already remotely running using the KENWOOD s/w for funcion control and the IP-SOUND s/w for sound transfer, via the RS232 and DATA TS480 connectors. My question is if REMOTERIG pair can be used alternatively via the proposed h/w configuration (panel, mic and key TS480 connectors), WITHOUT disconnecting the above existing PC h/w connections?
Also I would like to ask what is the estimated overall (minimum) latency on CW, if the particular path INET residual latency is approx. 20ms?