Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - LB4MI

Pages: [1]
1
Hi,
I am currently trying to set up my Remoterig RRC-1258 MKII (radio end serial: 13952, remote serial: 13941) using a Yaesu 857D.
The radio is at mainland, and remote end is currently at an island with satelite communication. Normally I use my Remoterig setup from my home without any issues at all. After I brought the remote end to the island, and made all the neccessary firewall changes on my new remote end, I can't connect.

The "ping" here to mainland are ca 600 ms. Is this a problem for the connection between the two RR boxes? Are there any maximum delay/ping they can handle? All IP-telephony from island works without any problem, so I would not think that this is a problem.



For the firewalls; at the radio end everything is configured from earlier, as my setup is normally working when I am at home QTH.
At my remote end, I have set up a static NAT to my island IP address, and opened UDP 15000-15002 (the ports I am using) to my remote QTH IP-address.



However, when I at remote end try to turn on radio, the  PWR lamp is flashing green. I think this indicates a DNS problem, but as shown from the STATUS pictures of both boxes, they are able to connect to eachother. Also the display on radio front is slightly flashing, which normally indicates some sort of connection problem..

Any advice? :)

2
General discussion forum / Local RRC gets stuck in CW keying
« on: 2021-07-21, 15:54:04 »
Hi,
I have successfully used the RRC boxes for remote operation for a year, with Yaesu 857D. Now the latest months with CW keying. Everything has been working as it should.
Now, after a three week summer vacation, where my local box has been powered off, it has started to behave strangely.

Everything starts up as normal. When I key with my paddle, i only get dits. No dahs. (Yes, all wiring is OK with key, it works OK connected to my local IC-7300, as it also did before).
When I unplug the mini jack from the local RRC box, the internal keyer in the RRC starts sending "dahs" non stop. This is only generated locally. This behaviour happens without any connection to the remote radio. I can even unplug my network cable, and radio display cable - and the same CW keyer issue appears. So the problem is not related to my remote end, its only a local problem.

I have tried the follwoing:
- restarted all boxes
- re-installed the last backup of my local RRC (bin file)
- tried a different CW key. (Both CW keys works perfect with my IC-7300)
- When I disable the keyer in my local RRC, the problem disappears as expected as keyer is disabled.

Attached are my local keyer setup, remote keyer setup,
and local box info/remote box info

Any suggestions?

Pages: [1]