1
Configuration, RRC 1258 / TR4W does not read the frequency from COM1 RRC1258MkII K3-Twin Control end
« on: 2022-01-10, 14:58:48 »
Greetings, colleagues!
I am using RRC1258MkII K3-Twin with loggers TR4W and sometimes WinTest.
The local PC is connected to an RRC COM1 port by cable with Prolific USB-to-COM driver.
If no loggers is running, the Remote Radio is controlled normally.
If any logger starts, the execution time of commands on the remote radio increases.
The reaction to the rotation of the encoder and to the pressing of buttons slows down.
The local and remote position are connected to LAN by an optical cable. Ethernet speed is 1Gbps.
Max ping time is less then 0,1ms. The sound in both directions passes without problems, both with logger and without them.
The main problem is the lack of a frequency readings in TR4W. At the same time, the commands typed in the TR4W (alt_M, alt_B and others) are executed normally. Mouse clicks on the bandmap spots set the K3 to the desired frequency, but with a long delay.
If K3 is connected to the PC with the same cable directly (without RRC system) to RS-232, TR4W reads everything correctly and does not slow down.
WinTest in the same setup reads the frequency normally, but still slows down.
Please, advise me how to achieve the correct operation of the K3-Twin with TR4W logger.
Nick, RM4F
I am using RRC1258MkII K3-Twin with loggers TR4W and sometimes WinTest.
The local PC is connected to an RRC COM1 port by cable with Prolific USB-to-COM driver.
If no loggers is running, the Remote Radio is controlled normally.
If any logger starts, the execution time of commands on the remote radio increases.
The reaction to the rotation of the encoder and to the pressing of buttons slows down.
The local and remote position are connected to LAN by an optical cable. Ethernet speed is 1Gbps.
Max ping time is less then 0,1ms. The sound in both directions passes without problems, both with logger and without them.
The main problem is the lack of a frequency readings in TR4W. At the same time, the commands typed in the TR4W (alt_M, alt_B and others) are executed normally. Mouse clicks on the bandmap spots set the K3 to the desired frequency, but with a long delay.
If K3 is connected to the PC with the same cable directly (without RRC system) to RS-232, TR4W reads everything correctly and does not slow down.
WinTest in the same setup reads the frequency normally, but still slows down.
Please, advise me how to achieve the correct operation of the K3-Twin with TR4W logger.
Nick, RM4F