Author Topic: RC-1216H - SteppIr SD 100 - Firmware 4.4 up - lost serial settings  (Read 3877 times)

dj3ng

  • Newbie
  • *
  • Posts: 6
    • View Profile
    • Email
Hello all,

last weekend I updated all my remoterig components with the newest firmware. Works fine, only trouble with RC-1216h 2.8v  to 4.16v. I lost the connetion between SteppIR Controler and SDA 100. Missed seriall settings: "No settings available for this device".  Downgrade to 2.8 and try higher version step by step, find serial settings only until Firmware version 4.0.
Need higher version no serial settings ?
At the moment RC-1216h with SteppIR works fine with V4.0 ...

73 de DJ3NG 

   

Jan (Microbit)

  • Software Developer
  • Administrator
  • Hero Member
  • *****
  • Posts: 1829
    • View Profile
    • Email
Since version 4.0 the serial settings used for SteppIR always are:

9600 baud
8 data bits
1 stop bit
No parity

Do you mean that v4.0 works but not version 4.16?
Always include type of hard/software and version when asking for support.