Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
(Hi all,
I am experiencing interruptions in my remoterig connection. I notice it mostly by interruptions in the audio (everything from 1 second to ~20 seconds). But also if turning the VFO the radio may become unresponsive for a while. And somethimes the interruption is so long so that the timeout error tone starts. The problem is erratic, sometimes it works flawlessly for an hour, but usually there are interruptions every minute.
While it could be a configuration error somewhere, I highly suspect my internet connection, but I find it very hard to track. A little bit about my setup:
I am using RRC1258 Yeasu TWIN with 2x Yeasu FT2000
On my control-QTH I have a fiber 1000/100 Mb/s connection (getting about 800Mb/s down and 100Mb/s up at speed tests). The router is a Linksys EA9500, and I run a 5GHz link (with Ubiquiti Nanobeam M5) between the house and my radioshack (about 20 meters). In the shack I use a TP-link 5 port gigabit switch.
On my radio QTH there is a 100/10 Mb/s fiber connection, run through a Linksys WRT54GL router, via a 5GHz link (Ubiquiti Nanobeam M5) to the radio (about 50 meters). A TP-link 5 port gigabit switch is used on the radio site as well.
I'd be very grateful for tips on how to track the error (obviously I have checked 5GHz QRM with the Nanobeam's Airview tool, but it seems fine), and I have some questions:
1) Is there any way to analyse the radio-site connection remotely?
2) Are there any tools to analyse the datastream? I mean to try and see what sorts of packets are lost, and if it's possible to see where they get lost?
73 de SM0UXX Erik
Same problem here...you have one photo of correct strip configuration?
Thanks a lot
PaoloHi,
Just trying to configure for my IC-7100. As far as I can tell everything is correct:
IP configured for local testing, both plugged into same switch.
Installed the required PCB on the Controller RRC as I have a later version 7100.
Correct links installed on the Radio RRC.
When I press the power button the back light on the mic keypad comes on, I hear a couple of clicks and the yellow leds on both ends come on for about 2s then go off and the backlight goes out. The display never shows anything.
On the web interface the SIP status is 'Unknown 1' which I understand is a timeout from other posts.
I've no idea what's going on and after several hours of trying have got nowhere. Any help appreciated.
Bob
Hi,
Just trying to configure for my IC-7100. As far as I can tell everything is correct:
IP configured for local testing, both plugged into same switch.
Installed the required PCB on the Controller RRC as I have a later version 7100.
Correct links installed on the Radio RRC.
When I press the power button the back light on the mic keypad comes on, I hear a couple of clicks and the yellow leds on both ends come on for about 2s then go off and the backlight goes out. The display never shows anything.
On the web interface the SIP status is 'Unknown 1' which I understand is a timeout from other posts.
I've no idea what's going on and after several hours of trying have got nowhere. Any help appreciated.
Bob
